Intex POOL MAINTENANCE KIT ASSEMBLY v.1 Manuel d'utilisateur télécharger pdf

(

81-1PO) POOL VACUUM & SKIMMER ENGLISH SIZE: 4.875” X 7.25” 07/14/2011

81-1

SAVE THIS INSTRUCTIONS

081-1PO-R1-1207

POOL MAINTENANCE KIT ASSEMBLY AND

OPERATING INSTRUCTIONS

IMPORTANT: READ AND UNDERSTAND THE INSTRUCTIONS COMPLETELY BEFORE

STARTING ASSEMBLY.

POOL VACUUM ASSEMBLY INSTRUCTIONS

1. Turn handle A and handle B clockwise and slide each section to extend or shorten the

length of the telescoping shaft (6). Turn counterclockwise to lock each section in place.

Clip the hose mount (4) on the shaft.

2. Tie the debris collection bag (3) onto the cleaning head opening opposite from the

garden hose connection, as you would tie shoelaces.

3. The cleaning head (2) has a plastic spring (1) that connects to the bottom shaft. Align

the plastic spring located inside the cleaning head with the holes drilled in the shaft.

Gently squeeze together the plastic spring tips so that the shaft slips onto the cleaning

head and the spring "pops" into the pre-drilled holes.

4. Depending on the type of garden hose connect the hose to the side opposite the debris

bag. Mount the garden hose on the shaft by clipping in the hose mount (4).

IMPORTANT: The flat washer must be placed into coupling before garden hose is

connected.

5. The pool vacuum is now ready to use.

POOL VACUUM OPERATING INSTRUCTIONS

1. Connect the garden hose to the water spigot and turn on the water.

NOTE: The water pressure varies in each community so testing will have to be

done to find the correct hose water pressure for optimum cleaning.

2. In soft gentle strokes "sweep" the entire bottom surface of the pool liner until it is clear of

debris.

3. Turn water "OFF", remove the pool vacuum from the pool, disconnect and place the

garden hose in a safe area.

4. Untie and clean the debris collection bag. Allow the debris bag to air dry. Retie the

collection bag onto the cleaning head.

5. Store the pool vacuum in an area where it will not be a safety hazard.

POOL SKIMMER ASSEMBLY AND OPERATING INSTRUCTIONS

1. The pool skimmer uses the same shaft as the pool vacuum’s.

2. The skimmer net (5) has a plastic spring (1) that connects to the bottom shaft. Align the

plastic spring located inside the net with the holes drilled in the shaft. Gently squeeze

together the plastic spring tips so that the shaft slips onto the net and the spring "POPS"

into the pre-drilled holes.

3. Gently sweep the surface of the pool with the skimmer net removing floating leaves, etc.

1 2

SAVE THIS INSTRUCTIONS 1

Résumé du contenu

Page 1 - SAVE THIS INSTRUCTIONS

(81-1PO) POOL VACUUM & SKIMMER ENGLISH SIZE: 4.875” X 7.25” 07/14/201181-1POSAVE THIS INSTRUCTIONS081-1PO-R1-1207POOL MAINTENANCE KIT ASSEMBLY AND

Page 2

Commentaires sur ces manuels

Pas de commentaire

Intex POOL MAINTENANCE KIT ASSEMBLY v.1 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Intex POOL MAINTENANCE KIT ASSEMBLY v.1. Intex POOL MAINTENANCE KIT ASSEMBLY v.1 User Manual [fr] [de] [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Intex POOL MAINTENANCE KIT ASSEMBLY v.1